6/11/2023 0 Comments E3d hemera weightIf you're using a ramps compatible main board, you will find that the main board end of the stepper motor cable included in the kit is likely not wired correctly. Observe & confirm/fix polarity of stepper coil wiring harness.Use Octoprint, pronterface, or similar software to send commands mentioned below. This will ensure you have a working motor before you mount everything, and be the easiest way to calibrate E axis steps per mm. If you have an identical hardware configuration, you can download my firware from my fork of Marlin at Verify and Calibrate Motor by doing a Cold Extrude before mountingĭo this step right out of the box, even before you thread in the heatbreak or heater block and nozzle. I'm not going to do a full guide, since I'm hoping one of the popular YouTubers who is capable of a high production quality video will do a comprehensive guide, but I have put together the following tips and lessons learned that should help some of you who are struggling but can't figure out why things aren't working.įor reference: I have an Ender 3 with an SKR 1.3 using Marlin 2.x, equipped with TMC2208's in UART and a BLTouch. I'm very familiar with Marlin 2.x, and so I finally decided to just go straight to the Hemera Datasheet, and finally got things working. However, as time went on with my install, I discovered each guide was missing critical information, had bits of information incorrect, or included firmware files in a old or flattened format, making it difficult to discern firmware changes required. I got the E3D Hemera (formerly called the Hermes) a week ago, and at first glance was impressed by the amount of documentation/guides E3D worked with popular YouTubers to create.
0 Comments
Leave a Reply. |